EVOLUTION 10.000 SURGICAL ASPIRATOR

Sterilization and Disinfection

Cleaning

This step must be followed periodically.

1. The product must undergo a disinfection procedure before use or reuse.
2. Check the perfect state of conservation of the power cord extension, collection bottle and secretion aspiration circuits.
3. There are no restrictions on the number of reuses of the product, only the restrictions on its perfect state of conservation should be checked.

• Fairing:
  Clean the outside using a cloth dampened with a mild soap and water solution.
• Bottle:
  • Disconnect the silicone tubes.
  • Remove the cap and empty the bottle with residue in an appropriate place.
  • Replace the cap, connect the silicone tubes and aspirate 500ml of water mixed with 150ml of solution enzymatic solution to clean the inside of the silicone collection tube.
  • Disconnect the silicone tube, remove the cap from the collection bottle, remove the O'ring and wash with a jet of water, until you are sure there is no residue left.
    Observation: Perform the procedure on the vial(s) that make up the equipment.
  • Wash and disinfect the collection silicone tube, as well as the aspiration cannula if used (Optionally supplied item) Repeat the procedures for each operation.
    NOTE 01:Reconnect the silicone tubes to the vial cap and after cleaning make sure that the silicone tubes are
    silicone are not inverted.
    NOTA 02: Do not activate the Surgical Aspirator with the silicone tubes disconnected and/or without the cap
    properly fitted to the collection bottle
  • Cleaning after using the float kit.

Disinfection

For collection vial, lid, tubes and cannula (optionally supplied item):

Peracetic acid – Prepare the 1% Peracetic Acid solution for high-level disinfection according to the manufacturer's instructions, keep it completely immersed in the solution for a period of 15 min. wearing gloves, rinse in sterile water and allow to dry at room temperature or in a dryer for a maximum of 15 min.

MAssemble the product and preserve it in order to keep it safe from contamination until use;

or

70% alcohol% – Keep it completely immersed in 70% alcohol according to the manufacturer's guidelines and let it dry at room temperature or in a dryer for a maximum time of 15 min., assemble the product and preserve it in order to keep it protected against contamination until its use.

ATTENTION
The Polycarbonate (PC) collector bottle IT CANNOT go through the process of disinfection with alcohol, as it will reduce the useful life of the bottle.

Sterilization

Follow the autoclave manufacturers instructions for temperature, pressure and time for:

• To clean;
• Remove float kit, except cap with level sensor.
• Pack the product to be sterilized individually;
• The piece must remain inside the chamber for 15 minutes at 121°C or 4 minutes at 134°C
• Do not place parts without proper packaging inside the chamber;
• Do not lean the parts against the chamber wall;
• Do not place pieces on top of each other.

Recommendations for collection bottle, lid, tubes and cannula.